Other Stuff > Misc / Open

Handlebar wiring inside or out?

<< < (2/3) > >>

Bryanj:
I think you have that the wrong way round Julie, the cutouts are for external wiring the non cutouts for internal and both should have pegs to fit in holes on the bars to stop rotation

Nurse Julie:

--- Quote from: Bryanj on July 03, 2024, 05:35:04 PM ---I think you have that the wrong way round Julie, the cutouts are for external wiring the non cutouts for internal and both should have pegs to fit in holes on the bars to stop rotation

--- End quote ---
You could well be right Bryan, it's been a while since I've had to fit switch gear ☺️☺️☺️☺️

Bryanj:
Same here but i literaly tripped over a box of switches this morning!!!!

Laverda Dave:
I'm with you on wiring on the inside Steve, it does look much tidier. Modern bikes these days are covered in cables from the handlebar switches, very untidy looking imho.

florence:
having on the inside is a pain if you need to work on them though.  When I built mine I cut a small bit out of the switch body to allow the cable to go outside.  This was back in 1995 when switches were cheap and easy to come by.

Navigation

[0] Message Index

[#] Next page

[*] Previous page