SOHC.co.uk Forums > The Black Bomber Board

CL450 - Crank split? to replace the bearing retainers

(1/2) > >>

nairb:
After a bit of research, I think one or other of the bearing retainers on the crank will need to be replaced after several chunks of metal came out when draining the engine oil.
The bearing retainers are shown in the following pic with red arrows.

[ Guests cannot view attachments ]

Before I start the engine pull down, I was wondering if I will need to get the crank re-built with the new bearing retainers.
I suspect it's the inner bearing retainers that are the problem.  And the crank will need to be split to get at them

Ta
Nairb

AshimotoK0:
My friend Graham Curtis rebuilds cranks ... he did my CB450K0, CB72 and S90 cranks.

nairb:
I think that means the crank will have to be split to replace those bearing retainers..... a bit like splitting the crank on a triple 2 stroke to replace the oil seals

AshimotoK0:

--- Quote from: nairb on July 17, 2024, 05:14:27 PM ---I think that means the crank will have to be split to replace those bearing retainers..... a bit like splitting the crank on a triple 2 stroke to replace the oil seals

--- End quote ---

Yes correct ... Graham Curtis has the press and fixtures to do it. I know he has done 4-speed bomber cranks as he did mine ..not sure he's done a 5-speed but he's deffo done CB350Ks/G5's that are similar in design. He always cleans out the sludge traps in the crank flywheels as they preferentially retain heavily compacted debris particles  in preference to the centrifugal oil filter. He has a real bee in his bonnet about it.

nairb:
Thanks for the info.  I have finally dug out the/a manual for the 5 speed engine (clymer)and gave it a look at.  I really dislike pulling a factory finish engine apart, and it's going to be the full job to get at those bearing retainers and check their condition...... Bugger.  The engine was still running OK.  It was the bits of metal that dropped out at oil change time that gave the game away.

Not looking forward to this at all.  Will I really have to split the cam chain..... the manual seems to say so.  2-stroke engines are So much easier.

Navigation

[0] Message Index

[#] Next page