SOHC.co.uk Forums > CB350/400
8000RPM "sag"....
Bryanj:
Reminds me of the customers 500 that wouldnt pull when he had it but was fine when we had it in, one day i was early and he was late dropping it off and i caught him opening the seat and removing his waterproof trousers! Sold him a bungie cord to hold them outside the seat and all problems cured
Mikep328:
Yeah - I'll sort of hijack my own thread... I have a friend who worked in a repair shop and liked to tell the story of a Porsche 911 turbo that was not producing the boost/power that it should. They confirmed that on the dyno and worked on the car for two hours before discovering the problem was that the floor mat had bunched up under the accelerator pedal!
Mike_Berkshire:
--- Quote from: Mikep328 on August 18, 2024, 02:37:57 PM ---Yep, the cover had slid back so as to obstruct part of the air intake!!! I removed it and the bike once again blasted through 8kRPM with no hesitation!
--- End quote ---
Serendipity - in a separate post I was asking how much of a problem it would be that I was missing certain parts from the airbox assembly including the tool tray and the perforated grill that sits in it - clearly no issue!
Mikep328:
I tried to order a new lid for the tool tray from the eBay site Ted listed but he said he is out of the lids and no idea when he would get more. :(
McCabe-Thiele (Ted):
--- Quote from: Mikep328 on August 19, 2024, 10:53:57 AM ---I tried to order a new lid for the tool tray from the eBay site Ted listed but he said he is out of the lids and no idea when he would get more. :(
--- End quote ---
That's a shame I suspect whoever is printing them will make some more, I've seen the 3D tool tray on e-bay via a different seller.
If I come across it I will post a link.
Found this old post on the top mesh part.https://www.sohc.co.uk/index.php?topic=21223.0
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version