SOHC.co.uk Forums > CB500/550
Rear hub d ring.
DomP:
I'd be interested too
McCabe-Thiele (Ted):
--- Quote from: DomP on September 03, 2024, 08:52:06 PM ---I used two thin orings next to each other to fill the gap which worked well as a substitute, I'll look up the size I ordered.
*58 ID x 2mm if I'm looking at the correct order in my shockingly long list of bike parts!
--- End quote ---
Two 2 mm wide O rings - 4 mm in total sounds wide but maybe not.
I've measured my old D ring it is 2.35 mm thick and 3.97 wide, it had been fitted with the flat section down. Your solution looks pretty close iirc the inner hub section groove is not flat but more rounded.
Johnny4428:
The d ring groove is about 4mm wide Ted.
McCabe-Thiele (Ted):
My measurements were taken with calipers so I probably pinched the rubber a tad. I gave up trying to measure the diameter for obvious reasons. I think I've read the 58 size previously.
Nurse Julie:
Johnny, I've found a D ring, in a box of big O rings 😁😁😁😁.
PM me if still interested.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version