SOHC.co.uk Forums > CB500/550
Rear hub d ring.
deltarider:
Maybe it's my English. Any pics of that 2x solution?
DomP:
Just use 2x 2mm orings in the 4mm groove rather than the rocking horse poo 'D' profile
Johnny4428:
--- Quote from: Orcade-Ian on September 04, 2024, 05:48:55 PM ---Hi Johnny,
Might be a bit of a long shot but I had special seals made for my Lake and Elliot trolley jack - different material but you never know.
http://www.stallard-engineering.co.uk/stories/other/Trolley%20Jack.htm
They were extremely helpful and many others have used their services using the link on my site. I only bought 2 of the specials and some other 'off the shelf' seals.
They are Barnwell Services (http://www.barnwell.co.uk/) - might be worth an email or call and I'm sure that if they can help it could be useful to others.
Ian
--- End quote ---
Positive response from initial email to Barnwell Ian, now awaiting further details. I’ll keep the forum posted of outcome.
Johnny4428:
After an initial positive response from this company I’m afraid I have come up against I think a non starter. The following email was the last recieved a couple of days ago. My reply to them was to offer to send them an original to take dimensions from, so far no reply.
Orcade-Ian:
That's a disappointment - I wasn't aware they had a place in Lanarkshire. Wonder if my original contact is still there in West Midlands? Anyway, you tried!
Ian
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version