SOHC.co.uk Forums > CB500/550

Throttle cable routing

(1/3) > >>

SteveW:
Can someone clarify if this is correct, it seems the only way I can get it to fit nicely.

Out of throttle, around the front of the right hand fork, under clock bracket, around headstock and on the inside of left hand fork. Down the left side of the frame tube and under to the carb linkage on the right.

550 K0

Seabeowner:
I can only comment on my 500K0 when it had it's original US bars but that seems about correct. The cables change from the left side to the right above the ignition coils

SteveW:

--- Quote from: Seabeowner on September 16, 2024, 06:55:40 PM ---I can only comment on my 500K0 when it had it's original US bars but that seems about correct. The cables change from the left side to the right above the ignition coils

--- End quote ---

Should they go through the hole in the frame where the coils mount?

At the moment I have them going under the frame, below the coils?

Bryanj:
Look in Ashs stash for the build and pdi dat its all in there

McCabe-Thiele (Ted):
On my 500 the throttle cables loop from the handle bars through the right side of the gap between the headlamps to the right side under the clocks straight along the right side of the frame passing on the outside of the right coil to the throttle bracket. Might not be original but a nice smooth run. I have UK bars on my 500.

Navigation

[0] Message Index

[#] Next page