SOHC.co.uk Forums > CB350/400

head bearings

(1/2) > >>

steven400/4:
just got some non standard head bearings from d/s [headrace bearings ]  do i still need to use the bottom steel washer and rubber washer witch you use with the gen bearings????
thanks steve

rigwit:
in a word .........yes both lower and upper, i'm assuming you are using new taper bearings for lower and upper, slap plenty of a good lithium based grease also put some in lower seal cup when fitting headstock and same in upper........ be prepared for some grease to escape...or be squeezed out when tightening up headrace.......... wipe over and away you go.........did same on mine in 79 cant remember the code for the bearings which is a bummer as sourcing from a bearing supplier,s is cheaper than buying via  a third party...

steven400/4:
i got them from d/s

Bryanj:
You can't get them from a bearing supplier as the outer race is ground special to fit

steven400/4:
i dont need any i need to know where the washer goes that comes with the race set

Navigation

[0] Message Index

[#] Next page