SOHC.co.uk Forums > CB500/550
Rear hub bearing lock ring.
Johnny4428:
Wasn’t certain it needed anything to lock it but that answers my question, thanks guys. Incidentally when I dismantled my rear hub the seal had been pressed into the lock ring not the sprocket cover!😳 didn’t think that was right. New seal in the correct place now.😜
McCabe-Thiele (Ted):
It's a while ago now but not sure that's correct I'll check my project build?
Update
I checked my build its for the sprocket so you are correct I tried to fit it in the retainer but it would not fit. I thought it was a duff retainer ring part from DS.
Johnny4428:
I was a bit the same Ted, didnt think there was any way the new seal was going to fit inside the bearing retainer.
Sesman:
Punched at four locations. I’d post a photo, but I lose the server when posting!
My file size is too large!
McCabe-Thiele (Ted):
--- Quote from: Sesman on October 03, 2024, 08:52:33 AM ---Punched at four locations. I’d post a photo, but I lose the server when posting!
My file size is too large!
--- End quote ---
Sorry I keep banging on about it but using the BBCode via flickr raises no problems with file size. Only issue is if you delete old photos they are deleted from your post so can be an issue for Steve, to avoid any repeat of Spamgate I don't delete what I've uploaded onto my photostream. Even decent modern digital SLR photos can be used.
If flicker goes kaput then I will have to shrink my files in a boil wash.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version