SOHC.co.uk Forums > CB750

Tacho slap!!

<< < (2/2)

AshimotoK0:

--- Quote from: brianm on October 26, 2010, 12:35:02 PM ---I connected the drill to the engine side of the cable and it was spot on. Is the damper inside the Tacho?
Brian

--- End quote ---

yes it's inside the Tacho just under the dial face.

See my other post today on the subject.

Cheers

Ash

daveh:
A few months ago I fitted a new cable to my KO as the reading was somewhat jerky. On fitting the new cable the tacho reading was still jerky and sporadic, however when I compared the original inner cable to the new one it was about a 1cm longer whilst the outer appeared to be the same length on fitting the old inner in the new outer the tacho behaves as it should. The cable was a genuine Honda from D Silver.

DaveH

steff750:
 ::) i have opened up a few clocks over the years and a good shot of lube will get things back to normal Honda clocks are pretty stable ,does anybody remember the old British clocks now we are talking "speedo bounce" and" rev counter slap"  ;) yes and you can also have a inner cable that is too short, that it will fall out of the rev counter drive,this has happened to me a few times  :-* as well as the cable being too long and getting tight , i think we need to remember that although this stuff comes from d.silvers and ebay it does not guarantee it is a genuine Honda part, there are still lots of reproduction parts out there especially cables, brakes, clutch, gaskets ,filters infact anything serviceable is and always will be copied by other motorfactors ,so sometimes we can get away with a mix and match,its all part of the fun i think  :-\

Navigation

[0] Message Index

[*] Previous page