SOHC.co.uk Forums > Project Board
Tels CB550 project
McCabe-Thiele (Ted):
--- Quote from: TezzerTel on December 07, 2024, 07:04:38 PM ---
--- Quote from: Johnny4428 on December 07, 2024, 05:27:43 PM ---That looks like a couple of butchered washers been home made for spacers or the like, as Bryan says not Honda parts. Bike is looking very good though, nice work. Some lovely RC aircraft in the background too!😜
--- End quote ---
Yes I've been building and flying RC aircraft for a few years now. If you think old Honda's are expensive try RC aircraft :o
--- End quote ---
I have a long standing friend who is into RC Helicopters using full control consul. After a few expensive crashes he has gone back to model aircraft.
TezzerTel:
I had a quick look at how my seal fits in the sprocket cover plate today. I lightly greased it and it just pops straight back out again. I had my cover plate powder coated so I'm wondering if that's the problem? I could try removing the powder coat from the bore where the seal fits and glueing it in place?
Bryanj:
Should be a reasonable press fit
TezzerTel:
It is a nice press fit but with grease it just pops straight back out. I'm wondering it the seal i have is to wide and/or there's a taper on my cover plate exaggerated by the powder coat?
McCabe-Thiele (Ted):
Parts book does not show dimensions.
Shown as 55 x34 x9 on Wemoto site.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version