SOHC.co.uk Forums > Project Board

Tels CB550 project

<< < (12/13) > >>

mickwinf:
ok my two pennyworth. you have a left and a right bracket there so correct. the later 550 are different to the earlier 500/550, as can be seen in your pic they are higher at one end, higher end to the rear of bike, the screw is in the front hole. brackets are handed, rubbers are not. will try to post a pic of my old 550 f2 which has the same set up as yours. edit still having trouble posting pics from laptop will try from phone

TezzerTel:
That makes sense it's a shame they didn't make the rubbers handed as well. One side matches the contour of the bracket but the other side will not

mickwinf:
Pic

TezzerTel:
Yes that's right but on the other side the rubbers doesn't lone up with the edge of the bracket?

TezzerTel:
I've finally found a bit of time to get back on the rebuild and back on the site!

So next question- would the intake manifolds be bare aluminum or painted the same as the engine castings from new?

Navigation

[0] Message Index

[#] Next page

[*] Previous page