SOHC.co.uk Forums > Project Board

Honda CB400NA Superdream - new money puddle.

<< < (22/60) > >>

McCabe-Thiele (Ted):
Down to the skeleton now.


.PXL_20241111_200316917 by Macabe Thiele, on Flickr

Laverda Dave:

--- Quote from: andy120t on November 13, 2024, 12:51:05 PM ---Dave - is £100  to check and straighten it as well?  Was that a spot on Watford?

--- End quote ---

Hi Andy.
The price included minor tweaks although if the frame is bent and needs heat it will cost more. The 350 Morini frame I took to him needed a crack on the rear seat rail welding up and that cost a bit more.
Howard who owns the business is very honest and is an ex aerospace engineer. He was building a wicked looking Norton Commando cafe racer in a Featherbed frame last time I was there.
The company is called Hybrid Motorcycles and they are located in Croxley on the road between Croxley and Sarratt. It is opposite a prep school and is just a driveway, blink and you'll miss it!

andy120t:
Thanks Dave. Not far from me so I'll investigate further.

McCabe-Thiele (Ted):
I'm planning to get Max (former member) to make me a set of SS wheel spacers for the Superdream so thought I would find them ready for posting out..

I found the rear spacers within a minute or so.  I have failed to find the front wheel spacer as it was not on the front axle bolt with the speedometer drive where I should have put it during dis-assembly.

I've checked all the boxes on the shelves yesterday & again today, it really bugs me when I can't find a part.

Laverda Dave:
I can 100% guarantee Ted they will be in last place you look!
I dropped the small centre pin that links the no 2&3 carbs on the 400 last spring. I looked everywhere and couldn't find it even sweeping the floor with a magnet. I bought another from Steve @400/4 bits.
I was tidying up the garage last week, pulled out a storage box from under the bench and sitting on the lid was......the carb centre pin!

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version