SOHC.co.uk Forums > Project Board
Honda CB400NA Superdream - new money puddle.
Bryanj:
Read my bits at bottom of posts
Of course it is in the last place you look---------- YOU STOP LOOKING WHEN YOU FIND IT
Laverda Dave:
😂😂
McCabe-Thiele (Ted):
This evening I've put some small tool racks back on the garage wall that I had to move to make room for my 400 & 500 at one end. I was fed up with rummaging for tools in boxes.
Honest I've not looked for the missing spacer at all, just been trying to think back 10 days. No point in looking in the same places for a third time, well not tonight anyway.☹ï¸
McCabe-Thiele (Ted):
Found it! 😄
Took another look this morning using a pencil torch to peer inside the front hub. On one side I could see the bearing & center spacer (left speedo drive side).
When looking at the other end there was clearly something else there as well as the inner spacer & the bearing, yep it was inside the hub seal where I had pushed it back in after inspection ten days ago.
McCabe-Thiele (Ted):
New problem found today - I'm hoping there is an easy fix.
The center stand pivot on the Superdream is held in place slightly differently. For some reason they changed the fitting so there is a clamp on the right side only plus a threaded bolt hole in the pivot that is tightened up with a bracket arrangement. I'm thinking that bracket is to ensure the stand moves on the shaft, rather than the shaft rotating in the frame clamps. No clamp on the left side unless it's missing.
When I came to remove the center stand shaft from the frame the bolt in the center was several threads undone so this did not prevent the shaft from rotating. Even worse still the center shaft was in fact broken near where it fits close to the frame acting like flexible joint, I actually thought briefly that it was a rag bolt design.
The original shafts are no longer available, the SD website sells a SS replica that comes with the center bolt. The new shaft is a nice bit of kit, it fits firmly into the frame on the right side - a different story on the left side as the hole in the frame has enlarged over time so it fits like you know what in a stocking.
Not sure at the moment what the easiest decent fix is going to be, my first thought is a steel or alloy plate needs to be fitted on the outside of the frame with the original sized hole in it for the shaft to be held in place. It might be the plate could be held in place by a couple of bolts or brazed in place not sure at the moment if there is an easier fix.
broken stand pivot by Macabe Thiele, on Flickr
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version