SOHC.co.uk Forums > Project Board

Honda CB400NA Superdream - new money puddle.

<< < (25/60) > >>

K2-K6:
Probably the simplest way to recover it would be to get a plate made (bespoke washer really) in something like 4mm plate, four holes drilled into that and just placed correctly! then with welding through the holes to frame structure to secure. 

Holes  unless you know someone with a spot welder, local bodyshop etc ? that may do it as adhoc job for you.

That'll give an easy install and competent bearing surface in bore to repair it.

McCabe-Thiele (Ted):
I've resurrected my Brass olive, if I can sand it down a tad more it might work

McCabe-Thiele (Ted):
The Brass olive is an interference fit on the shaft when I push the shaft fully home from the other end, on assembly I will pop some Loctite on the outer edge of the olive and shaft contact.

It has been suggested elsewhere that Brass might be too soft due to the weight of the bike.
As it's a tight fit with the shaft being double held at the other end by the usual clamp plus a bracket bolted to the center of the pivot to stop it rotating it might be good for a few years.



.SD pivot 1 by Macabe Thiele, on Flickr

Bryanj:
I think thats a great fix Ted, worth telling the other forum

McCabe-Thiele (Ted):
I've posted a picture on the Real SD Forum Bryan, only comment to date was that brass is a bit soft, suggesting the weight of the bike might be an issue. I'm happy to monitor the situation and see how it works out.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version