SOHC.co.uk Forums > Project Board

Honda CB400NA Superdream - new money puddle.

<< < (33/60) > >>

McCabe-Thiele (Ted):
Starting to recover from the coughing bug.

When my brother helped me remove the engine I put it on this newly acquired 6 wheeled trolley.
I was able to pull it up the ramp onto the bike stand with ease, no help needed.

I plan to fully clean the engine and paint it without full dismantling, hence the catch tray.
Obviously the underneath will be the more difficult part.

.PXL_20241218_094500265 by Macabe Thiele, on Flickr

Bryanj:
Drain it and turn it upside down mate

Johnny4428:
Fine to see it progressing Ted and glad to hear your on the mend! These spacers look ace! Might have to consider a set for my next project, which will be swerving away from what Honda intended!😜

McCabe-Thiele (Ted):
Feeling much better today so I spent  40 minutes in the garage before the cold started to get to my knees.
I removed the starter motor from the casing, put a bung in the casing to keep dirt out for when I resume cleaning the assembled engine.

The starter motor on the Superdream is at the front of the engine so it gets all the weather & road grime on it, also my model did away with a kick start leaving a bump start as the only alternative if the starter fails. As I have a couple of spare working starter motors that came with the bike I'm not going to dismantle the starter (never taken a bike one apart yet) just a clean of the alloy ends  & paint the steel casing part methinks.

This is the motor after the first petrol wash & quick clean with a soft brush in theb Dremel Tool.

.PXL_20241228_140026310 by Macabe Thiele, on Flickr

Orcade-Ian:
Greetings Ted,
Glad you are improving - this stuff that seems to be going around takes longer to shift as we get older!
Anyway, I would personally strip the starter - especially without a kick start as back-up.  There's never been much wrong with the ones I've stripped but often found quite a bit of brush dust (always worth removing) and an occasional brush sticking in the holder, which is often the reason for them not working.  Is it the same as 400/4?

Ian

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version