SOHC.co.uk Forums > Project Board

Honda CB400NA Superdream - new money puddle.

<< < (35/60) > >>

McCabe-Thiele (Ted):
The two long screws are very tight, they have been there since 1980., more soaking in releasing oil. I'm going to use my old fashioned lump hammer driven impact tool tomorrow, might add a bit of heat with my electric paint stripping gun.

Worse case scenario is saw through the bolts then put bolt shaft in vice and turn

Orcade-Ian:
Ted, if you grip the plain part of the long screws in the vice with a little bit of clearance between the body and the vice, you can then rock (twist) the body a few degrees back and forth and the screws will let go, especially after a bit of heat at the thread and head ends. I've not been beaten yet and those had not been moved since 1975!

Ian

McCabe-Thiele (Ted):
Never thought of that Ian, good tip.

McCabe-Thiele (Ted):
This morning I decided to follow the advice given by a number of members and dismantle the starter motor.

The first  long screw came out pretty easily using Ian's tip, clamping the long bolt and moving the starter motor body, then with my JIS screwdriver it loosened up nicely. Part nipped it back up to do the second side.

On the second screw it was seized solid on the none threaded end, after a lot of messing about getting nowhere I cut through the bolt shaft with my Dremel cutting Disc (brilliant cutter courtesy of Ken) the threaded end undid  easily when I put the bolt shaft in the vice.

I clearly cut the other end off too close to the housing cap so I have drilled off the JIS head and washer. I've cut the other side off as close to the housing as I could get.  The un-threaded shaft does not want to come out, it's at times like this I miss a Pillar drill.

At present I've put the end cap in the freezer whilst I gather up the energy to drill out the small remaing bolt part, tapping with a center punch has faied to move it, likewise heat from my heat gun. I might need to look at a way of pressing it out, not that easy as the housing has a sort of lip to hold the O ring in place.

Meanwhile looking at the starter motor shaft, the commutator has no step worn in it, I've wiped off the light carbon deposit with some meths on a rag.  Not sure what to use the clean the rest of the rotor with. The contact screw to the live terminal on the brushes was loose.

The light brown coating on the main part of the starter motor rotor (?) part is missing at the drive end, I can't see any contact marks with the outer coils so not sure if this is normal?

Superdream commutator by Macabe Thiele, on Flickr

Rozabikes Tim:
Ted

Pillar drill you miss. If space isn't the issue, I'm clearing out my deceased dad's house next weekend. There is one there you are welcome to FOC. Its only an Aldi Parkside affair but does the job (I have had one for years)

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version