SOHC.co.uk Forums > Project Board
Honda CB400NA Superdream - new money puddle.
McCabe-Thiele (Ted):
--- Quote from: Rozabikes Tim on December 30, 2024, 04:14:28 PM ---Ted
Pillar drill you miss. If space isn't the issue, I'm clearing out my deceased dad's house next weekend. There is one there you are welcome to FOC. Its only an Aldi Parkside affair but does the job (I have had one for years)
--- End quote ---
I have no idea how much room I need for a Pillar drill, I'll PM you.
McCabe-Thiele (Ted):
Back on the Starter Motor, at the output gear end there was a pronged washer plus two shims plus what looks like a fibre washer. I failed to record what side the fibre washer fitted! Is it towards the commutator or the three pronged washer?
The brushes are 10.80 mm long, they look okay, no idea what the new or minimum length should be.
McCabe-Thiele (Ted):
I had a response from an e bay seller, new brushes are 12 mm in length, mine are 10.8 mm so probably just bed in.
Looking at it logicaly the two thin shims go against the commutator boss, the fibre one will be against the pronged spacer to act as a cushion.
The casing seals are intact, at almost £18 for the two from DS I'll use what I have, I'll just fit a new seal on the outer boss where it goes into the engine.
McCabe-Thiele (Ted):
Spent an hour or so in the garage, cleaned up one of the starter motor end caps.
Not going to go too mad with polishing (sorry Ken) as you can barely see it once fitted.
.PXL_20250102_151612720 by Macabe Thiele, on Flickr
McCabe-Thiele (Ted):
Starter motor back together & works off the bike.
.PXL_20250107_201938498 by Macabe Thiele, on Flickr
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version