SOHC.co.uk Forums > Project Board
Honda CB400NA Superdream - new money puddle.
McCabe-Thiele (Ted):
Thanks for the comments, not going so well with the footrest bracket polishing. I moved from Kens Plastic wheels to my buffing wheel too soon.
Result is the edges are good but the main flat areas look like the craters on the moon. Going back to using the plastic discs is hard work as the surface is so smooth.
Not sure what to do now, I'm thinking of using Wet & Dry in a sanding block to rough it all up again, possibly 320 grit.
Oddjob:
You need some fine flap wheels Ted, good for large flat areas. The ones you find on eBay tend to only come in 80 grit but there are some 40, 60, 80, 120, 180, 240 and 360 versions available if you know where to look. I’ll pm you a link tomorrow but they need adapting to fit a Dremel.
Honda enthusiast:
When the surface has gouges or heavy pitting, I use a fine flat file and file it smooth, then 320 lightly, a lot of 400 and then 600 followed by a coarse sisal mop on the bench grinder with black soap...and then medium mop with green/yellow soap and finally polish with fine mop and white soap and then hand finish with solvol.
There's phone advice and mops/soaps here https://www.thepolishingshop.co.uk/
And a good powerful bench grinder like the 750 watt SIP makes things much easier..https://www.sip-group.com/product/category/106/sip-10%22-professional-bench-grinder/07650
Also get a decent respirator Ted and a balaclava plus goggles it's a dirty job and you don't want that in eyes or lungs 😊👍👍
K2-K6:
As you've surmised Ted, likely you'll have to "flat" it with file or block type abrasive arrangement to reduce undulations in surface.
You can use one of those house decorators rubber/Cork material blocks to facilitate abrasive materials. They'll give softer edge to help work around the area that has a boss sticking out too.
Light pressure cuts with 180 grit should bring it back to flat plane first, then successive increases in grit number to take it finer.
Use paraffin or "maintenance spray" from Asda to keep it lubricated as you work, this to prevent pickup and risk of a gouge from that being pushed across the surface. Maintenance spray is cheaper than wd40 :) it's how wind tunnel aluminium models were hand finished a while back.
The effect you've currently got is a little like aluminium cylinder bores that use a flexible hone to remove material around harder particals in the casting, called a "Hypereutectic" tool to particularly target this effect.
McCabe-Thiele (Ted):
Thanks for the tips Ken,HE & Nigel.
Interestingly I've found Solvol dulls my final Soap finish.
Ken has found a Gold Ultra fine finishing Soap.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version