SOHC.co.uk Forums > Project Board
Honda CB400NA Superdream - new money puddle.
McCabe-Thiele (Ted):
--- Quote from: Laverda Dave on October 14, 2024, 10:17:09 PM ---
--- Quote from: McCabe-Thiele (Ted) on October 13, 2024, 11:46:22 PM ---The genuine seal at DS is £19.70, aftermarket part £9.00 is the cheaper option as good?
The top seal/washers are £7.70 each, so it's a total of £35.10 or £24.40 - just to cheer me up there might be a second leak lower down!
--- End quote ---
For the sake of an extra £10 I would always go for the genuine part (assuming the DSS part is genuine Honda and in a Honda bag). Imagine fitting a pattern part and it still leaks, you wouldn't know if it was the pattern part or another issue. If a genuine part is still available I would always use it just for peace of mind that you know it's correct and it will fit properly.
--- End quote ---
I've come to doubt a lot of parts that are in bags marked Honda much like genuine NGK plugs that look the real deal.
The advice on the Superdream forum was they use aftermarket ones without issue.
As I have a spare top cover I will check it sits on the cylinder head as it should without the seal in place.
It appears that a PO has tried to put sealant including silver paint on the joint area so I'm hoping it's just some bodgery.
McCabe-Thiele (Ted):
--- Quote from: K2-K6 on October 15, 2024, 09:14:27 AM ---An interesting project Ted, looking forward to seeing it progress.
Isn't the rocker cover fitted and secured by two sleeve bolts on these with rubber seals ? Much like a A series BMC type but with that T fitment instead of traditional cork ;D
--- End quote ---
Yes Nigel very similar to a BL A series rocker cover, if you under or over tightened the cork gasket they would leak.
Looking at my spare top cover the top mounting holes look like a slightly tapered recess with a bolt that has a metal/rubber sealing washer .
When I take the tank off I will know more - the old parts books are pretty poor on detail. Ken told me that when fitting if you were not careful the sealing ring could be knocked out of place, it could then split or just become trapped. I think Bryan or Ken mentioned it was worth applying an adhesive to keep the profile correct in the cover groove.
Bryanj:
They aint cheap but its worth changing the rubber cones on the bolts as the bolt tightens down to a built in stop so if cone deteriorates cover is looser
McCabe-Thiele (Ted):
I will be replacing the top seal arrangement - DS sells them.
A PO has fitted new front brake lines with no guide brackets on the mudguard for the two calipers the skinny braided hose in white just look wrong.
Original replacement guid brackets are NLA so looks as if I'll have to find some aftermarket ones to fit my none genuine front mudguard. The existing front mudguard looks nice enough as a plastic replacement, I just need to find a pair of brackets that will fit.
Johnny4428:
No guides or brackets in your stash of spares that came with the bike Ted?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version