SOHC.co.uk Forums > Project Board

Honda CB400NA Superdream - new money puddle.

<< < (41/60) > >>

davidcumbria:
Have you tried these Ted ? I have found the plastic wheels work on engine covers etc but these flap wheels are effective on harder material. Very useful to have as an option


https://www.ebay.co.uk/itm/186399186277?var=0&mkevt=1&mkcid=1&mkrid=710-53481-19255-0&campid=5338268676&toolid=10044&ff=11&customid=CjwKCAiAnKi8BhB0EiwA58DA4clKHFvQARjxQTEB50xeSIXUKaILM9TJmjJBGi5p8tQA4Q0h5PAmJBoCFecQAvD_BwE

taysidedragon:
Ted, I came across this classic bike dealer/breaker when looking for something. He has a whole load of 250 Superdream parts for sale. There may be something that you could use. See pic attached.

McCabe-Thiele (Ted):
Thanks TD I'll give them a ring, the wheels in the photo are reverse comstars probably for a CB250NC.

I did expect the rear drive cushion rubbers to need replacement, on removal not only were they all hard as rock, a PO had wound some sort of cloth type tape around the four drive lugs to make them a tighter fit, you can see the material in the right of the photo.

.PXL_20250117_111431162 by Macabe Thiele, on Flickr

McCabe-Thiele (Ted):
So during todays mild weather did my first clean of the Comstar rear wheel in an effort to clean the grime off the hub center and the back of the spokes where the Spiders have been living.

Just used some Bilt Hambler Surfex-HD to start with, revealed a sort of pale yellow colour on the inside, might be paint, might be how they left the factory. These wheels seem harder to clean than normal spoked wheels. Not used the jet washer yet, I'll persevere with an old tooth brush and the cleaner for a couple more times.

Photo is after the first clean.

. PXL_20250121_134236393 by Macabe Thiele, on Flickr

ST1100:

--- Quote from: McCabe-Thiele (Ted) on January 21, 2025, 01:53:40 PM ---...revealed a sort of pale yellow colour on the inside, might be paint, might be how they left the factory...
--- End quote ---
Likely like/similar to Alodine, zinc chromate or zinc phosphate corrosion inhibitor...

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version