SOHC.co.uk Forums > Project Board

Honda CB400NA Superdream - new money puddle.

<< < (42/60) > >>

McCabe-Thiele (Ted):

--- Quote from: ST1100 on January 22, 2025, 07:48:21 AM ---
--- Quote from: McCabe-Thiele (Ted) on January 21, 2025, 01:53:40 PM ---...revealed a sort of pale yellow colour on the inside, might be paint, might be how they left the factory...
--- End quote ---
Likely like/similar to Alodine, zinc chromate or zinc phosphate corrosion inhibitor...

--- End quote ---

An old post on here has suggested the spokes are Cadmium plated on some variants.

K2-K6:
Your examples look like all aluminium Ted. That's from details I can see in your photo.

Some were steel spokes with satin chrome and have clearly different appearance from the all alloy fitment.

Both rim and spoke on all aluminium are effectively  "forged" by rolling of that material. It makes them particularly resistant to surface cracks etc, as such forming a characteristic within their long term performance. 

Anodised to finish, again it very effectively protects the structural integrity by not allowing propagation of any corrosion points into fissure that would degrade them.

They are pretty tough and resilient generally, but I'd ideally try to conserve the original surface and not use anything abrasive on them if possible. 

The paint on internal surfaces doesn't look original. Agree it appears a proprietary type coating that could be from aircraft industry norm that's been applied.

High acid or alkaline type cleaners (road film remover ? ) can cause the anodised layer to go "milky".

K2-K6:

--- Quote from: McCabe-Thiele (Ted) on January 22, 2025, 09:00:58 AM ---
--- Quote from: ST1100 on January 22, 2025, 07:48:21 AM ---
--- Quote from: McCabe-Thiele (Ted) on January 21, 2025, 01:53:40 PM ---...revealed a sort of pale yellow colour on the inside, might be paint, might be how they left the factory...
--- End quote ---
Likely like/similar to Alodine, zinc chromate or zinc phosphate corrosion inhibitor...

--- End quote ---

An old post on here has suggested the spokes are Cadmium plated on some variants.

--- End quote ---

"CAD" plate usually looks yellow in appearance a little like yellow passivated zinc from my experience a long way back.

K2-K6:
Ooh, forgot, check spokes with a magnet to give binary id, steel or not  :)

McCabe-Thiele (Ted):
Thanks for your replies Nigel, the spokes must be some sort of alloy as they are definetely not steel, I tried my small torch magnet, then double checked with a very powerful aquarium magnet, zero attraction.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version