SOHC.co.uk Forums > Project Board

Honda CB400NA Superdream - new money puddle.

<< < (44/60) > >>

K2-K6:

--- Quote from: Bryanj on January 22, 2025, 05:41:19 PM ---I thought stainless was rarely magnetic, unless cheepo stuff

--- End quote ---

Properties can shift according to alloying mix and the attributes those bring.

"Types of stainless steel
Stainless steel comes in over 57 types of standard alloy, as well as numerous custom alloys produced by stainless steel manufacturers. The composition of each type varies. Based on their metallurgical properties and microstructures, stainless steels can be divided into five categories:

Austenitic Stainless Steels
Ferritic Stainless Steels
Martensitic Stainless Steels
Duplex Stainless Steels
Precipitation-hardened Steels
The Duplex stainless steel combines austenitic and ferritic crystals, so it offers the best of both worlds and is magnetic whilst also having generally greater corrosion resistance than the austenitic 304 and 316 stainless steels."

Quoted from here https://www.eclipsemagnetics.com/resources/guides/are-all-stainless-steels-magnetic/ some are more condusive to welding, while work hardening etc also varies.

McCabe-Thiele (Ted):
With the milder spell I have started to assemble some of the frame bits over the last few of days, center stand is in place.
Steering shaft outer races fitted to steering column, painted the front steering shaft ready for fitting bottom race and fitting the column. A taper roller kit that was cheaper than the standard ball bearing races, old bearings were well rusted. (JMT Kit was from M&P on offer at £10.18)

The kit came with a bottom spacer, I will be fitting an improved bottom seal that is attached to a thin spacer rather than the rubber original type. I have a selection of thinner bottom spacers that I can use left over from my 400 build.They are steel JCB bucket shims in various thicknesses that are the correct i/d & o/d. My bearing puller tool will remove a bottom race undamaged if I need to change the spacer under the bottom bearing.

McCabe-Thiele (Ted):
Not much of an update really as cold spell with no warm house to retreat into has slowed down progress.
Frame is on the bike stand, hit a snag with my fix for the worn frame hole for the center stand, not a big snag but enough for some cogitating to occur. When the center stand is used the return spring pushes the stand boss towards the olive that I made.  >:( >:( >:(

I have a cunning plan Lord Black Adder. ;D ;D ;D
#
#
#
#Frame after powder coating by Macabe Thiele, on Flickr


McCabe-Thiele (Ted):
The brake lever/pivot sleeve is somewhat sloppy due to wear, both the lever & the insert are NLA.
Hard to work out which part has the most wear, the collar or the insert

What is the way forwards to fix this sort of problem?
Presumably members working on rarer model Hondas  come up against this problem.

Bryanj:
Probably a brass bush turned to fit the worn shaft and the hole for the insert

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version