SOHC.co.uk Forums > Project Board

Honda CB400NA Superdream - new money puddle.

<< < (46/60) > >>

Bryanj:
Ah well me and Ted are too old to look over our shoulder(s), the arthritis wont let us turn that far!

McCabe-Thiele (Ted):
The brake pedal from T Northeast (Kens search) arrived today, I'm not sure if it's a period repro or NOS tbh. There were a couple of old labels on the shaft held on with very brown selotape.

It needs a little bit of Solvol-Autosol in a couple of areas to clean off a few minor rust spots, absolutely no movement using the existing center collar. That's saved the need for a new center collar as well, nice one Ken.

I think I have found an answer to tidying up the Comstars after a few email exchanges with Camcoat, another hot tip from Ken.
Full Ceramic coating was way out of my budget at £432 plus carriage for the pair. The manager Nick Adams has come up with an interesting alternative a matt silver Ceramic spray for £85 per wheel plus Vat, Sounds very promising.

Oddjob:
If it’s got those labels it’s a nos one, I think they are attached by the main depots back in the day

McCabe-Thiele (Ted):
I'm going to have to remove the wheel bearings from the Comstar wheels prior to painting, the manual says no lock rings, just drift them out? That's not what I expected!

McCabe-Thiele (Ted):
I've just removed the wheel bearings  prior to deciding how far to go with improving the look of my Comstar wheels.

At one end of the spectrum I'm looking at an inexpensive option, a powder coated chrome/alloy look (like my fork ears) for £80 ish for the pair. At the other end of the scale £432 at Camcoat. I've never compromised on wheels rebuild costs before,  being mindfull of end cost v value I'm still uncertain what to do.

Anways enough of my blabbering thoughts, a new question here about wheel bearings. The rear wheel bearings were replaced in 2014 at 49,561 miles, the bike has only covered 1,117 miles in the last 10 years or so. The front bearings look original so I will replace them.

The rear wheel bearings are a bit of a conundrum as there is quite a lot of general surface rust where some water has managed to get into the rear hub affecting the outside of the left side bearing, some rusting of the hub steel band & the outside of the spacer.

Does the grease in a wheel bearing go hard with doing so little mileage in 10 years, the left seal is a modern fully sealed one, the right side is sealed only on the outside. Am I skimping to even consider putting them back in?




Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version