SOHC.co.uk Forums > Project Board
Honda CB400NA Superdream - new money puddle.
Bryanj:
Ted, just go to a bearing supplier and order by number on the outer race, specify 2RS type, you will probably get all 4 for less than £20.
I would even use fleabay ones
Oddjob:
Short answer, yes.
From looking it looks like you need a 63042RS and a 6303ZZ for the rear wheel and 2 x 6302ZZ for the front. If the bearings come out with only a metal or plastic seal on one side only then just remove one seal from the new bearings. Rs are plastic seals, ZZ are metal.
Try Hendersons, SKF or NSK are a good make. Around £5-6 each.
McCabe-Thiele (Ted):
Thanks Guys, I'll check the markings on the existing bearings & oil seals.
Updated
Ordered seals and bearings from bearingsrus came to £19.18
Bearings are by Dunlop, I'll never wear them out at my age.
McCabe-Thiele (Ted):
I've just started to add a few items to the frame, I've fitted the wiring loom to the frame as the air box is so close to the frame the loom will not fit afterwards.
Honda never listed the air box to carb rubbers separately so there is no part number(s) listed.
Aftermarket ones are available as a separate item but do not seem to be handed. My rubbers look okay but appear to be handed, my two are either both left side or both right side?
McCabe-Thiele (Ted):
My Comstar wheels arrived back from Camcoat today. I went for a basic wet ceramic spray satin silver/alluminium colour finish to save on cost. TBH they are a tad darker than I expected, that said they look much better than they did. I'll post some photos later.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version