SOHC.co.uk Forums > Project Board
Honda CB400NA Superdream - new money puddle.
McCabe-Thiele (Ted):
My BiL came today to help fit my engine in the frame.
Dave jacked it up whilst I tilted it to get it in place, took about 30 ins with faffing about & being careful.
Just fitted the rear and front mounting bolts in place, I need to check a few things like bolt orientation before I tighten up the flange nuts.
#PXL_20260813_111906403 by Macabe Thiele, on Flickr
Laverda Dave:
Always a major victory when the engine goes back in, the end is in sight :)
Oddjob:
Try doing this Ted. We found that if the engine bolts were tightened with no regard to engine position the engine buzzed or vibrated. Try loosely fitting all the bolts, lift the engine a little with the jack and then check every bolt. If every bolt slides in and out the engines in the right position, if even one drags or resists being moved the engines needs to be repositioned slightly until they all move easily. Only then do you tighten the nuts. It’s a bit of a faff but the results seem worth it.
K2-K6:
Good work Ted, and decent progress.
At least you're not getting cold in this weather currently ;D
McCabe-Thiele (Ted):
--- Quote from: Oddjob on August 13, 2026, 03:55:19 PM ---Try doing this Ted. We found that if the engine bolts were tightened with no regard to engine position the engine buzzed or vibrated. Try loosely fitting all the bolts, lift the engine a little with the jack and then check every bolt. If every bolt slides in and out the engines in the right position, if even one drags or resists being moved the engines needs to be repositioned slightly until they all move easily. Only then do you tighten the nuts. It’s a bit of a faff but the results seem worth it.
--- End quote ---
Thanks Ken, does the top double triangular block bracket get fitted last?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version