SOHC.co.uk Forums > Project Board
Honda CB400NA Superdream - new money puddle.
davidcumbria:
Good luck with the resto Ted looks like a good buy and that model would also high on my list as an interesting rideable bike in the end. Getting started on my BMWR80 soon after I’ve sorted a near engine death belt issue on my Volvo Xc60. Hope the thumb gets better !
McCabe-Thiele (Ted):
It's weird the bloke I bought my CB400NA from has sent me a photo of his latest bike, another CB400NA, at a glance it looks in quite similar condition overall.
Might be he is buying & selling or that the one I have was just too much work with the comments by a previous bike repairer about the engine being delicate.
Having read all the history of the bike a few times it had new genuine Honda block & standard pistons fitted in Oct 2015 at 48,859 miles it has now covered a recorded 50,678 miles with documentation that supports the recorded mileage and lack of use.
Looking at the statements dated August 2019 at 50,646 miles "this engine is delicate and would not advise being taken apart again " this might be why the last owner has decided to move it on.
The upper crank case has had some Timeserts fitted with a report of oil leaking from cracks in engine casing as far back as 2014. Reports do not seem to specify if it was the lower (gearbox) casing or the upper. There is a decent lower engine/gearbox casing in my box of spares.
Looking around on e-bay it appears that stripped head bolt threads are pretty common. Worst case scenario is I either need to find a better upper crank case or the existing one will need more head bolt threads repairing. There is no sign at the moment of any slow oil leaks from the engine when it is not running.
I've seem a few adverts for complete 400N engines, I suspect stripped head threads is pretty common - makes me wonder why Honda did not stick to studs & nuts.
Pretty sure the engine is going to end up being fully dismantled, I still plan to fire it up again when the cam top cover is back on just to see if there are second or third areas of oil weeps/leaks.
I'm planning/hoping to have her running again by the end of the week - currently having to cope with a water leak somewhere under the bath area that is causing a small circular damp patch in the rear lounge.
Plumber calling tomorrow to give me an estimate.
.damp patch circle by Macabe Thiele, on Flickr
Johnny4428:
Ted in my opinion any thread repairs if carried out competently will be stronger than original threads as you probably know. So I wouldn’t be put off by previous repairs, cracks is a different story. More annoying would be a water leak in the house!😳
McCabe-Thiele (Ted):
--- Quote from: Johnny4428 on October 21, 2024, 05:45:47 PM ---Ted in my opinion any thread repairs if carried out competently will be stronger than original threads as you probably know. So I wouldn’t be put off by previous repairs, cracks is a different story. More annoying would be a water leak in the house!😳
--- End quote ---
The optimist in me did wonder if the so called 'cracks 'were casting marks. If the bottom casing has cracks can I fit the 'spare casing' I have assuming the bottom cases are interchangable with the upper half as the mains arrangement is an internal coded mains cap arrangement?
As you can imagine the water leak (a small damp patch at the moment) is my priority. I've made a small hole at the centre of the circular patch with a bucket directly below just in case it suddenly accelerates.
Today there has been what appears to be one drip onto some dry loo roll in the bucket. It's how the plumber will find the source of the leak and what needs to be removed to fix it.
Bryanj:
Yes the lower case can be swapped Ted
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version