SOHC.co.uk Forums > Project Board
Honda CB400NA Superdream - new money puddle.
McCabe-Thiele (Ted):
--- Quote from: Bryanj on October 21, 2024, 08:56:06 PM ---Yes the lower case can be swapped Ted
--- End quote ---
I have since looked at the 400N parts book that is quite different from the CB400F & 500 K1 versions.
Two part numbers are listed for the 400N depending on the engine number, I have a spare lower crankcase but not sure if the two part numbers are interchangeable.
The book lists 11200-413-781 & 11200-413-782 so whilst not disputing the swapability wondered if there is some easy way of identify the spare casing I have as a 781 or 782?
Is it connected to the so called kicker models Bryan?
Bryanj:
Probably Ted, never got that far in. Did change top set on a brand new 250 but thats a different story
McCabe-Thiele (Ted):
My thumb wound is sufficiently healed so this morning the cam casing has been cleaned to remove the worst of the oxidation followed by a coat of Simonize silver matt engine paint.
McCabe-Thiele (Ted):
I am pleased to report that the cam cover oil leak is fixed with no sign of any other oil leaks.
I'm pleased I removed the coils & CDI unit as it made fitting the cover back really easy. I used Red Rubber grease to hold the seal into the cover, carefully put it in place, checked it was in place all the way around. New top seals & bolts fitted.
I've made a replacement cable for the battery to solenoid lead using some new cable & one new soldered end connection. I reclaimed a 90 deg terminal for the battery end. Not perfect but a good temporary arrangement until I can source something closer to the original battery terminals. Had to use the gas ring on the cooker to get the terminals hot enough for the solder to flow.
Sesman:
Never mind all that…what’s happening with the leak?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version