SOHC.co.uk Forums > Project Board

Honda CB400NA Superdream - new money puddle.

<< < (15/60) > >>

McCabe-Thiele (Ted):

--- Quote from: Sesman on October 24, 2024, 04:07:52 PM ---Never mind all that…what’s happening with the leak?

--- End quote ---

History, I have no oil leaks now!

Next going to do an oil & filter change & check the balance shaft chain for tension. I've had advice on how to do it from Bryan & Ken.

Sesman:
The water leak Ted, the water leak🫣

McCabe-Thiele (Ted):
Ah sorry I was in bike mode!
We have a low threshold bath as Wendy can't get her leg over due to hip replacement a few years ago. ( bath not me).
We have a fancy electronic shower with a fixed rain head plus  the usual hand type shower head on an adjustable rail. It's a power shower with a folding side screen so it uses almost as much water as a bath.

Plumber came on Tuesday and declared no leaks from the various pipes at the foot of the bath. He was a bit stumped as to what was causing the obvious wet patch on the lounge ceiling. He tried the bath taps no leak on the drain from the bath. As a last resort he asked me to switch on the shower. Nothing for the first few minutes then water appeared between the end of the bath and the stench pipe cladding in the corner of the bathroom. He did a video with his phone.
The bath is not dead level but tilts slightly away from the taps and the shower section. During a long shower then water runs along the seal between the bath & the wall tiles and was leaking at the far end.

After our house fire the cladding was pulled away from the walls by the fire brigade to ensure there were no small pockets of fire that could restart after they had left. Although the bathroom was not damaged the cladding had to be replaced due to the holes they had made in the uPVC. The builders just sealed in the new cladding but the joint where new met old failed to last.(It's lasted 6 years).
It just needs all the sealant round three sides to be removed and replaced with a good quality sealant with the bath full of water until it's dried.

I've decided to let them do it, sounds too much like removing gasket material from an engine block.🥱🥱🥱

AshimotoK0:
Charlie finally got round to pricing his Ted plus he has another one now if anyone else on here wants to share your journey  ;D

https://www.oxfordclassicmotorcycles.co.uk/bikedetail.aspx?bike=5518

[ Guests cannot view attachments ]  

https://www.oxfordclassicmotorcycles.co.uk/bikedetail.aspx?bike=5536

[ Guests cannot view attachments ]

McCabe-Thiele (Ted):
It took a while for it to be priced Ash, more in line with the current market, might be I got it wrong, I know it was more than I wanted to spend plus it probably needs little work doing to it.

The bloke I bought my 400 SD from has gone and bought another 400SD one with 16k miles on the clock from somewhere near Chester for £1800 IIRC, I saw it when I was looking for one, it's dropped a few hundred.
Too tidy for me I need something that needs working on.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version