SOHC.co.uk Forums > Project Board

Honda CB400NA Superdream - new money puddle.

<< < (20/60) > >>

McCabe-Thiele (Ted):
This morning as Wendy has gone with some friends to watch Arsenal v Chelsea I had a fresh look at safely removing the front wheel.

I must have been too tired yesterday to see the obvious. Wheel is out, good tip from the SD site about putting some wood under the center stand to lift everything up - never thought of that.

McCabe-Thiele (Ted):
Only the center stand left to remove plus the outer steering column races if on inspection they need replacing.

Then some serious degriming next week then I'll need to decide if it's powder coating (PC) or rattle can, might end up PC as the weather will be turning soon. If I go for PC then the damper bushes will need to come out.
 
.close to bare frame by Macabe Thiele, on Flickr

Sesman:
If you don’t mind me saying so, please don’t rattle can the frame. Unless you intend to use 2K. I have yet to witness any rattle can solution that exhibits an appreciable level of durability. I accept I’ve led a sheltered life.

McCabe-Thiele (Ted):
I spoke to Ken yesterday he pretty much convinced me to go for powder coating so that is going to most likely be the route I will go Phillip - I know it makes sense.

Laverda Dave:
Ted, before spending a heap of cash restoring the bike please get the frame checked for alignment. The guy I used asks for the engine cases to be mounted in the frame along with the swing arm, shocks and rear wheel. He charges £100 (used to be £70 a couple of years ago but that's inflation). The only bike that didn't need a tweak was Ratty the 400/4 but all the other frames I've taken to him in the past including a 350 Morini, 250RSA and 400/4 were all slightly out of line. He did say that most mass production frames are never 100% when they leave the factory as they are mass produced in jigs and very rarely checked.
I would hate to spend £000’s restoring a bike only to find it doesn't handle properly on its first outing because the frame is bent.
Considering the age of the bike, number of previous owners and obvious hard life it's lead I personally would get it checked.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version