Other Stuff > Misc / Open

Bodge of today post.

<< < (3/3)

Johnny4428:
I noticed that indeed Ted, quite a bit of metal gone from that.

McCabe-Thiele (Ted):
Probably never seen any grease since it left the factory 44 years ago.

K2-K6:
This type brazing rod https://www.ebay.co.uk/itm/176271717134 would be suitable for filling the wear point.

Then refinishing by hand file to leave original diameter with hard wearing surface.

Needs flux and gas torch to work with it. Anyone locally welding with oxy-acetalyne kit should be able to lay that on in a couple of minutes.

McCabe-Thiele (Ted):
That's interesting Nigel, I have a plumbers type Butane Gas Torch, I had briefly considered solder that would be far too soft.

Navigation

[0] Message Index

[*] Previous page