SOHC.co.uk Forums > CB350/400

Carb Spacer - screw head

<< < (2/2)

Orcade-Ian:
Of course, some penetrating fluid and or heat (he's replacing them hopefully) and I forgot to mention another tool in my arsenal is a tiny Teng ratchet which takes 1/4 bits including JIS which are sometimes better than screwdrivers - it's only 3 1/2" long and be wedged sometimes with a block of wood to prevent the bit from 'camming out'.  In the decades that I've been struggling with these and similar recalcitrant little buggers, I've not been beaten yet!

[ Guests cannot view attachments ]

[ Guests cannot view attachments ]

Ian

Mikep328:
Thanks guys -good info!  I went out and fooled with it a bit and decided for now to leave things alone!  I was concerned that if something went badly wrong I could end up with a problem that required serious work to resolve.  So I put the one screw back in and re-fitted the carbs.  We have a ride planned for tomorrow and based on the way screw-removing was going, I didn't want to jeopardize that.  I think the new carb insulators will be a project for next year!

Navigation

[0] Message Index

[*] Previous page