SOHC.co.uk Forums > Project Board

Ken’s 400 4 rebuild

(1/4) > >>

Ken4004:
Hi Guys

As promised some pictures of how my project is progressing , I am just looking at rebuilding the wiring loom by adding new tape around the loom and cutting off and fitting new bullet connectors and changing all the break points.

I will send photos of my three exhaust pipes in another post the first is the original which is in quite a state, the second is one a picked up off eBay a few years ago which is in a fair condition and the last is one I bought second had in Japan which is excellent condition which is the one I am obviously going to use the only issue is a scrap where it was grounded on the under side.

Ken4004:
The photos are a bit blurred due to too much compression let me try again

Ken4004:
That’s better the first ones didn’t do it justice

McCabe-Thiele (Ted):
Much better photographs, the build looks very good, is the rear fender for a US model?

I only ask as the number plate bracket seems quite a lot shorter than mine.

PS I am not a purist btw as can be seen from my photo below.

.400 lamp change 2 by Macabe Thiele, on Flickr

Ken4004:
Yes your right I bought the rear guard in Arazona the original was completely shot

Navigation

[0] Message Index

[#] Next page