SOHC.co.uk Forums > CB500/550
What's going on here?
Bryanj:
Dont forget the shaft is held in the clutch cover casting as well
McCabe-Thiele (Ted):
Not sure if this helps this was when I assembled mine, at one point with a washer in the wrong place.
http://www.sohc.co.uk/index.php/topic,29348.msg281517.html#msg281517
.
500 kick start by Macabe Thiele, on Flickr
.3rd Oct 2022 by Macabe Thiele, on Flickr
.gear shift levers etc by Macabe Thiele, on Flickr
Mike_Berkshire:
--- Quote from: McCabe-Thiele (Ted) on November 16, 2024, 12:57:50 AM ---Not sure if this helps this was when I assembled mine, at one point with a washer in the wrong place.
--- End quote ---
Are you talking about the washer don't eh shaft that in your picture is behind the circlip Ted? I hope so because in mine it is in front of not behind the circlip although I guess this is your 5500/4?
McCabe-Thiele (Ted):
You are correct about the washer it's my 500, that photo was during dismantling as can be seen by the dirt - I put the washer in the right place on assembly with a new circlip as advised by Ken. Just thought it might help seeing what is where.
McCabe-Thiele (Ted):
This is assembly iirc.
.500 casing progress by Macabe Thiele, on Flickr
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version