SOHC.co.uk Forums > Project Board
TL125S
Bryanj:
Not off hand mate but im sure its one ofvthevfour legs on a honda pullrt
Laverda Dave:
I have a couple of three leg pullers Bryan. They are not Honda items but I'll try one of the threads and hopefully it will fit......
Bryanj:
Try looking at cmsnl parts list sometimes they have the special tools listed at the front and the part number should give you size
K2-K6:
--- Quote from: Laverda Dave on December 17, 2024, 10:08:37 PM ---I have a couple of three leg pullers Bryan. They are not Honda items but I'll try one of the threads and hopefully it will fit......
--- End quote ---
Car wheel bolts are often available in this size area and pitch. Just don't get caught borrowing one out of a neighbour's car to try it ;D ;D do that at night ;D
Also, coppaslip or similar on threads (rotor or puller) exerts significantly more load onto the item to be pulled than dry threads do when you tighten them.
Bryanj:
Looking at the parts list it looks to me like the coils are in the outer cover and the rotor is a permag hollow one, if so any "legged" puller will probably damage it.
It may be an 18mm or 16 mm thread but use a HT bolt as it will need to be done up really tight.
The 4 legged Honda puller is a cross with a different thread on each leg, i have one but you are a bit far away.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version