SOHC.co.uk Forums > CB500/550
David Silvers Wiring Loom
TezzerTel:
I've got the David Silvers Wiring Loom for my 550 but the wire colours are different. Obviously I've asked them if they have any information on what should be what but they are no help. Has anyone else found this and worked out what's what?
McCabe-Thiele (Ted):
That's why I went for the Elextrex one on my 400, all original colours plus marginally cheaper, not sure if they list your model.
Someone here might have fitted the DS one, when I have encountered similar issues on bar switches there is usually some sort of logic where they use a lot of black wires with a trace colour that matches the original single colour. eg Light Blue becomes black with a light blue trace. Another issue is the original colours can fade quite badly so a lot of blues & light greens look similar, stripping back the wire on the original loom to reveal an unfaded colour can help.
On my 500 I just replaced the connector blocks and repaired the loom bindings & soldered in some replacement bullets as needed..
deltarider:
--- Quote from: TezzerTel on December 17, 2024, 11:54:42 PM ---I've got the David Silvers Wiring Loom for my 550 but the wire colours are different. Obviously I've asked them if they have any information on what should be what but they are no help. Has anyone else found this and worked out what's what?
--- End quote ---
Have you verified the loom is meant for your specific model including its 'area code'? Consult CMSNL.
Bryanj:
Is yours block connectors or seperat wires mate
TezzerTel:
All the plugs and connectors are the same as the original just the wires are different colours
Navigation
[0] Message Index
[#] Next page
Go to full version