SOHC.co.uk Forums > CB500/550
Idiot Bulbs and Holders
Bryanj:
I have seen complete pattern assemblies but cant remember where, maybe 4 into 1 in us
McCabe-Thiele (Ted):
IIRC I bought the complete loom with bulb holders on my 500 from a seller in Germany.
BigAl (Alan):
Once you have the rubber lamp-holders the sub-harness can be repaired
Mike_Berkshire:
--- Quote from: McCabe-Thiele (Ted) on December 21, 2024, 04:10:17 PM ---Any of this any good to you Mike ?
The three rubber type covers on the left I think are NOS given to me.
Bulb holders are used but not rusty inside.
Just the cost of a Jiffi bag & postage if you want them.
.PXL_20241221_160639275 by Macabe Thiele, on Flickr
--- End quote ---
Yes please Ted! Please send me a PM of what to pay you and how. Much appreciated!
Mike_Berkshire:
As an associated question; what good soldering irons/stations are there for working on the electrics of these old bikes? I have 3 different irons and none of them seem to perform well. I am, or was pretty competent at soldering as part of my job was building circuit boards and electronic calibration tools in my early career. Maybe there was more lead in the solder then and it worked better. Any recommendations greatly received!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version