SOHC.co.uk Forums > CB500/550

CB500 K0 Wiring Harness Routing

<< < (2/3) > >>

TezzerTel:

--- Quote from: McCabe-Thiele (Ted) on February 01, 2025, 11:37:59 AM ---Does this help, it's out of the 500/550 manual?

--- End quote ---

Yes that's what I couldn't find!

I guess my question is does it still take the route under the triple tree if its the model with the steering lock under there?

McCabe-Thiele (Ted):
Mine is like in the diagram, main loom passes under the tank rubber then goes back up going in between the top and botton steering yokes if that the right terminolgy. IIRC I added a 400 type wiring clip that goes under the left tank rubber, can't be sure there was not one there before.

TezzerTel:

--- Quote from: McCabe-Thiele (Ted) on February 01, 2025, 01:06:37 PM ---Mine is like in the diagram, main loom passes under the tank rubber then goes back up going in between the top and botton steering yokes if that the right terminolgy. IIRC I added a 400 type wiring clip that goes under the left tank rubber, can't be sure there was not one there before.

--- End quote ---

I see that as going under the bottom yoke?

McCabe-Thiele (Ted):
You are right,  yes it does (though the picture is not very clear), my frame did not have that side clip shown in the diagram as I have no fork ears, my loom dangled down really low before I stripped it down, I had a spare 400 clip so I used that as an alternative.

.32174377000P_large by Macabe Thiele, on Flickr

TezzerTel:
So now I'm thinking under the bottom yoke but clipped up out the way of the steering lock?

Navigation

[0] Message Index

[#] Next page

[*] Previous page