SOHC.co.uk Forums > CB350/400
Something I can't find
Mikep328:
You are WAAAAY more dedicated than I am...I would just wire brush the screw/nut shoot it with some aluminum paint and call it done!!!
Seabeowner:
4mm x 13mm cheese hd on the 500s. Probably the same.
https://www.ebay.co.uk/itm/321490372837
Skoti:
--- Quote from: Seabeowner on March 12, 2025, 06:41:08 PM ---4mm x 13mm cheese hd on the 500s. Probably the same.
https://www.ebay.co.uk/itm/321490372837
--- End quote ---
Those ebay ones are the standard 0.70 thread pitch tho, which are very easily obtained.
It may be the fine pitch ones that are 0.50 required?
Athame57:
--- Quote from: Skoti on March 12, 2025, 06:52:14 PM ---
Those ebay ones are the standard 0.70 thread pitch tho, which are very easily obtained.
It may be the fine pitch ones that are 0.50 required?
--- End quote ---
Does it actually matter very much? :-\
Skoti:
--- Quote from: Athame57 on March 12, 2025, 07:04:39 PM ---
--- Quote from: Skoti on March 12, 2025, 06:52:14 PM ---
Those ebay ones are the standard 0.70 thread pitch tho, which are very easily obtained.
It may be the fine pitch ones that are 0.50 required?
--- End quote ---
Does it actually matter very much? :-\
--- End quote ---
It won't screw into the bracket if it's the wrong thread.
Better to remove the bolt and measure it with a thread gauge first and establish which thread it actually is.
Good luck
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version