SOHC.co.uk Forums > CB350/400
400 F2 rear Brake torque arm
Mikep328:
Good point, of course! I didn't realize there was concern about that actual "structure" of the piece. Yeah - not an item you'd want to fail!!!
Oddjob:
Measure how long it is Mike, from middle of hole to other middle of hole. I'll see if the 500/550 one is the same, broadens the search out if it is. Might even have a spare myself. I buy swinging arm that that them still attached so might have a spare from those.
McCabe-Thiele (Ted):
The steady arm on my CB400NA Superdream is approx 370 mm long, I have a spare NOS one available if it's suitable.
Not sure how critical the geometry is on the design length.
exvalvesetdabbler:
Thanks all. I'm not in need of one right now, I was just cleaning up a few bits in my spares box while I had a zinc plate bath on the go and got curious about the numbers stamped on it. The 400N is a different middle part number so probably not the same.
Regards
Dave.
andy120t:
I'm sure I have one somewhere that's just a flat bar, or with a rib down the middle. Is that a 550 of some sort - no danger of it rusting from the inside, and easy enough to make up a replica.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version