SOHC.co.uk Forums > CB350/400
Hendler Air Filters, will these fit?
Athame57:
Does anyone know if these Hendler air filters will fit a CB400F? I'm determined if anything to eliminate the hell of the fitting the airbox chamber back to the rubbers everytime I want to go near the carbs! ;D
https://www.motorcycleproducts.co.uk/35mm-x-75mm-power-air-filter-pod-hendler/1/023933
McCabe-Thiele (Ted):
I suspect some change of jetting/needles etc will almost certainly be needed when fitting pods.
I have a set of spare 400/4 carbs that are mounted on the manifold.
I can send you some measurement of the distance between the carb inlet centers and the diameter of the boss the rubber fits onto if that helps.
I'm laid low with a bug at the moment, PM me of you want me to take some measurements.
Athame57:
--- Quote from: McCabe-Thiele (Ted) on June 24, 2025, 03:43:45 AM ---I'm laid low with a bug at the moment, PM me of you want me to take some measurements.
--- End quote ---
Get well soon Ted :) I hope your bug ain't as bad as the phuemonia I had a while back! :o I'll pm you. ;)
Johnwebley:
Get well soon Ted
Sent from my SM-A546E using Tapatalk
Mikep328:
I know absolutely nothing about this from personal experience on my CB400F but everything I've read - and I did a lot of searching - indicates that it's very difficult to sort the carbs out with pods. I don't think I've seen a single thread anywhere that claimed it actually did anything but reduce the bike's drivability. OTOH, I'd sure be interested in it if it works!!!
I have a lot of experience with other bikes using aftermarket air filters as well as totally unfiltered velocity stacks with good results. Not sure why the same wouldn't occur with these 400's/appropriate jetting/needle changes but nothing I've read SO FAR indicates good results in doing so.
Navigation
[0] Message Index
[#] Next page
Go to full version