SOHC.co.uk Forums > CB750

Zinc Plating on Sandcast Site

(1/3) > >>

AshimotoK0:
http://cb750sandcastonly.com/smf_forum/index.php?topic=376.0

Cheers

Ashimoto

UK Pete:
Hi ash interesting subject, i read all the posts but could not see any pictures
Pete

AshimotoK0:
Hmm Pete the pictures come up when I view it.

Here they are again

The wheel rim one is for my K0 - trying to establish if it is the early rounded type - Bryan?  Steff?

Cheers

Ashimoto

Seamus:
I had a go at zinc plating a few years ago, but had little success. It could have been because the kit I bought was not very good. I did obtain a decent power supply though.
I found a local zinc plater who was very reasonable and plated parts for the next day. Decided that it was not worth the effort.

I accept that if you can get the plating process to work, then doing it yourself gives a lot of satisfaction and probably convience.

Good luck with it

Bryanj:
Cant help with the wheel mate, never new there was a difference, there is only one part number for the rims throughout the range in the early parts book i have

Navigation

[0] Message Index

[#] Next page