SOHC.co.uk Forums > CB500/550
alternator / rotor nut removal .
Gromitdog:
Ok I was hoping the sharp impact of the air tool would be enough to start to undo the bolt ? But will bear in mind I might have to hold the rotor too
Laverda Dave:
The sudden shock of the air ratchet is normally enough to loosen it. I don't think I'd be trying to hold it with my hand and be careful if you try and wedge something in there to stop it turning as you don't want it spinning and hitting the crankcase breaking a chunk off.
Bryanj:
Long before rattle guns became cheap a ring spanner and lump hammer used to work
Gromitdog:
Hi Laverda Dave & Bryanj
Thank you for your useful comment on where not to grab hold of duly noted...... Might be worth a little heat on the main steel lump before I attempt the air tool ? Nothing wrong with a large heavy hammer 🤗😂
Bryanj:
Heat will make no difference, may even make the rotor expand and tighten the bolt, unless you can heat just the bolt.
The bolt is done up tight but will undo, the rotor is just on a taper with no keyway.
Have seen several rotors ruined by trying a 3 legged puller!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version