SOHC.co.uk Forums > CB350/400
Gearbox Stuck - The last straw?
SeanFD:
Which direction does it move when going up through the gears?
I can only move things anticlockwise, 4-5 "clicks".
That reference hole on the drum doesn't move at all.
I have 2 settings:
1. Rear wheel and shaft turn together - each one turns the other in both directions. As I said earlier, it doesn't feel like it gets easier/harder or /faster/slower as I move through those 5 clicks.
2. Wheel and shaft are separated; each can turn independently.
Bryanj:
It is very difficult to diagnose long distance but from what you are describing i think something is assembled wrong, at leasr you dont have to take any top end stuff off to check
SeanFD:
She ran OK, with noting feeling wrong for a short while, so I would think it is more like something has come adrift or broken.
Anyway, I'll not be taking anything further for now; I have to go home and prepare to finish my odyssey - I still haven't heard if Iran is issuing visas again yet.
So just when I thought I could jump into the water, looks like I'll be sitting on the bank for another while; probably be Xmas before I'm back to try and finish the job.
My general philosophy: It'll be all right in the end. If it's not all right ....!
SeanFD:
OK, so I went out this morning just to reassemble everything and put it away, but of course I couldn't just do that, could I.
I got this video once things were back together.
https://youtube.com/shorts/3N8Lcwp9agM?feature=share
It looks to me like the selector drum has rotated because that locator pin is too far anticlockwise when compared to the only other shot I could find of it on-line.
[ Guests cannot view attachments ]
With mine the way it is, the actuator has only two lugs to act on.
Bryanj:
I rhink it can only do that with the gearshafts out
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version