SOHC.co.uk Forums > Project Board

550 tacho drive project

(1/2) > >>

Gromitdog:
I am just doing some R&D on the possibly of having some of these machining up 12451323000.
The guy doing the machining has a few more steps to do before I get one back and can see if it all fits and spec is better than what's currently on the market.

Quick picture update. What do you think ?? Comments welcome.

Not sure why I can't get this picture to enlarge when you click on it Since found out picture was taken while is was cutting

Bryanj:
Enlarges for me, tap on a pic then two fingers, looks good

Gromitdog:
 Bryan
Thank you hopefully might get to see it next week.

Johnny4428:
Yes, interested to see finished unit when fitted.

Gromitdog:
Just as a update Will is going to see if a friend can put the grove in up the side which I take it allows the oil to get up / down, This is machined from a 50mm alloy bar so higher quality, The test peice it is currently roughly machined out as per picture.

It then has to have a finish machining process done which Will buys in for his machine to do it when he has got enough to warrant the high cost of program which his machine uses which then gives him 30days to do it.

 
Hopefully in another 3-4 weeks I be able to show you a finished one and will be able to run a batch off which hopefully will be for less than currently on offer

So If you think you might need one keep a eye on this post

Nige

Navigation

[0] Message Index

[#] Next page