SOHC.co.uk Forums > CB500/550
Hondabond or?
neat street:
--- Quote from: Athame57 on July 20, 2025, 08:37:35 AM ---This is a very good seiries of five videos on rebuilding a CB400F engine, full of tips and tricks too:
https://www.youtube.com/watch?v=vR-MiqdHi1w&t=36s
--- End quote ---
yes, great video, unfortunatly the gears and the forks on the 500 are in different halfs of the crankcase :-( would be much easier if it was the same.
Bryanj:
No, you assemble everything in top half of 500 and fit lower case over fitting primary shaft after
neat street:
Thanks Brian, will check that out. not sure how that works, but will test try tomorrow. :-)
neat street:
Yesm what a numpty I am, Brian your a star, could not weait till tomorrow and all is going to plan now. Thank you all so much for your help and comments.
Bryanj:
Just make doubly sure all the bearing dowels are properly located before tightening!!!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version