SOHC.co.uk Forums > CB350/400

Front Fork Lower Allen Bolt

<< < (3/4) > >>

Laverda Dave:
I pushed a length of wooden broom handle down the sanction to compress the spring tight against the damper to stop it turning.
Make sure the seat where the copper washer sits is absolutely clean, being so close to the road it gets a lot of muck thrown at it.

exvalvesetdabbler:
My method was a little less dignified.

Clamped the slider in a B&D workmate so that it's feet were held  quite a way off the floor and then sat on the workmate with the slider between my legs compress the spring. Then hammered away at the impact driver taking care not to miss.

Regards
Dave

JEZZAIRONBRIDGE:
Fork Seal fitment.
I am replacing Seals that have previously been replaced.
Need to be sure I am fitting them correct way up, or down.
If previously fitted wrong would like to be sure I am now fitting them correctly.
Can you advise how to tell.
Many thanks.

exvalvesetdabbler:
The open side with the spring visible goes down

JEZZAIRONBRIDGE:
My new Honda Seals have Seals inner and outer
Part number 91255 413 881 from D. Silver.

Navigation

[0] Message Index

[#] Next page

[*] Previous page