SOHC.co.uk Forums > CB750

A bit of a conundrum ? CB750K1 ?

<< < (2/2)

Grewth:

--- Quote from: Bryanj on August 11, 2025, 08:19:22 PM ---Personaly i would remove the "patches" and do a better job

--- End quote ---
That's not a "patch" it's the original saddle plate that the side stand mount was welded to.
Whoever cut the mount off did a wonderful job of removing any grinding marks, it's dead smooth.

archmill:
Grewth, fancy a frame kit ?
Means you can install the engine in big lumps (bottom end / barrels / head / top end) or install the engine built up a lot easier.

Grewth:
I think that my poor old frame has been mutilated enough already,  without hacking the top rails to bits.
If you build a 750 four motor properly in the first place, it shouldn't need pulling down again for 50,000 miles or so.
Even the F1 motor I threw together from three tea chests of bits was still running strong 20,000 miles later

Navigation

[0] Message Index

[*] Previous page