Other Stuff > Misc / Open

Wiring connectors, what size are Honda?

<< < (2/3) > >>

SteveD CB500K0:
The surface effect only works on AC circuits and then only very high frequency AC. So on DC and normal household wiring the effect is minimal.

Multicore wire is more flexible though so that’s the reason to use it.


Sent from my iPhone using Tapatalk

BigAl (Alan):
The electrical connectors on the 1970's models would have had 3.9mm bullet & socket connectors & possibly 6.3mm latched block connectors (for additional lighting)
The early 1980's models where fitted with 2.8mm latched block connectors.
Cable size 1.00mm...nothing smaller

mickwinf:
I beg to differ from big al but most 70s honda used 3.5 mm and 3.9 don't always connect with original looms.

Laverda Dave:
Thank you all for the responses.
I did ask BigAl previously if he made looms for the TL125 but unfortunately he doesn't but he did give me a helpful tip to use Vehicle Wiring Products to buy the connectors. I have just placed the order for £50 worth of cable and connectors. Shame they dont stock the rubber boots used to cover the multiple connectors of the loom around the headstock area (normally sitiing under the fuel tank.
I hope they are 3.9 and not 3.5 othherwise I'll be sending them back!
Hopefully I'll begin modifying the loom this week.

mickwinf:
If you are replacing both male an female connectors together then no problem.

Navigation

[0] Message Index

[#] Next page

[*] Previous page