SOHC.co.uk Forums > CB500/550
Swing Arm Bushes
deltarider:
Thnx!
Murf:
I got some grease nipples for my SA bolt a couple of weeks ago at the Newark auto jumble, a guy had a tub of them all old stock with various unknown threads they cost 10p each😀.
The ones I chose have taper threads and I think are either whitworth or BSP, we will see when I get around to putting them in. I have a whitworth tap and die set I bought for about 19/6 when I was 14 with my paper round money so it’s going to be a cheep job 😂
I think the grease nipples are from the same era so it should all fit together nicely👍
Oddjob:
Sorry Murf but why would you ruin a perfectly good metric thread to install an imperial one. Plus they are straight cut threads not tapered. A M6 x 1.00 45 degree angled nipple is dirt cheap, so why not just buy one and save all the hassle of trying to alter the threads. If you ruin it you risk having to buy another swinging arm and if it’s not tight on the threads the grease will just pour out of there instead of going where it should.
Murf:
Hi Oddjob
The original grease nipples on my bike a 75 US K1 are on the ends of the SA pivot bolt and are just a push in fit and not threaded so I have to cut new threads anyway, I wouldn’t just damage good threads so I could use my 10p bargain nipples. There is no grease nipple on the SA itself.
I have added a photo of the grease nipples I have which as you can see have that slight taper thread that many grease nipples have. I will identify the thread before I start and of course if the existing boring in the SA pivot pin is too large I will get some different nipples for it.
To be honest I just bought the ones I have on the spare of the moment because they were so cheap 😁
I can post a photo of my pivot bolt with the push in grease nipples tomorrow. If I remember correctly they look exactly the same as the ones on a 1964 CB 72 I had back in the day.
Oddjob:
Sorry Murf, thought you were replacing a 550 one.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version