SOHC.co.uk Forums > CB500/550

Float bowl drain screws

<< < (2/4) > >>

Murf:
After many tries I did manage to get through on the phone to them at the beginning of the year, I was after some Keihin carb jets, which they didn’t have and wouldn’t be getting. I seem to remember that the guy on the phone did not seem very interested.

DomP:
Im sure it was NRP that i spoke to about resetting my xs650b for its pod filters, its missing the entire filter setup and replacements are near impossible to find for a 1975 and elements if available are extortionate.  The guy seemed reluctant to help insisting I was wasting my time. 

Seabeowner:
I use a screw with clear tube attached to check fuel height that was sold for a z650, so their thread is the same. And probably others.

https://www.ebay.co.uk/itm/305867222628

DomP:
Out of interest what pitch is the tread on these?

Bloggs:
I think it's M6 fine thread. 6 x 0.75
I'll check tomorrow,  I did draw up the screws.
I made replacements with 12mm hex heads and a screwdriver slot. The slots always get damaged so a hex head helps.

Navigation

[0] Message Index

[#] Next page

[*] Previous page